Updated November 2026
Landscape edging that allows drainage keeps water from pooling behind a border, so soil stays firm, mulch stays put, and the edge stays straight. The key is to build in small gaps, weep holes, or permeable sections while still holding the line between lawn and bed. This guide walks through how to plan those openings, set the edging, and avoid the mistakes that cause washouts and frost heave.
Why Edging Can Block Water
A continuous barrier of metal, plastic, or stone acts like a dam when rain runs across a sloped lawn. Water collects on the uphill side, saturates the soil, and eventually pushes the edging out of line or floods the bed behind it. Solid concrete or buried timber is especially prone to this, because nothing moves water past the barrier.
Shopping for one? See our guide: 6 Best Easyflex No Dig Landscape Edging Kit Options for Clean Lines (2026).
Drainage matters most where grade changes, where downspouts discharge onto the lawn, and where beds sit lower than the turf. If any of those apply, plan for water passage before you dig.
How to Build Drainage Into Your Edging
You have three practical options. Use one or combine them, depending on the material and slope.
- Leave regular gaps. Set separate edging pieces with a 1/4-inch to 1/2-inch joint between them. Stone and paver edgings handle this well, and you can fill the joints with pea gravel to keep soil from washing through.
- Cut weep notches. For continuous strips such as steel or plastic, cut or drill notches about 2 inches wide at the low points, spaced every 8 to 10 feet on sloped runs.
- Set a gravel base under low sections. Dig a trench 4 inches deep, add 2 inches of crushed stone, and set the edging on top so water can flow beneath the base.
Checking the Slope
Before setting any material, run a string line along the planned border and measure the drop from the high point to the low point. A drop of 1 inch or more over 10 feet is enough to justify weep notches or gaps at the low end. Mark the lowest spots with a stake so you know where to focus your openings.
Step-by-Step Installation
- Mark the border with flour or landscape paint and confirm the slope with a string line.
- Dig the trench to the depth your edging requires, plus the 2-inch gravel base where needed.
- Set the edging with your planned gaps or notches, checking that each piece sits level or follows the grade you want.
- Backfill with soil or gravel on the bed side, tamping lightly so the edging stays upright.
- Run a hose across the bed after installation and watch where water goes. Adjust joints or add notches where it ponds.
Tools and Materials Checklist
- String line and stakes
- Spade or half-moon edger for trenching
- Level (4-foot or longer)
- Crushed stone or pea gravel for base and joints
- Rubber mallet for setting pieces
- Hacksaw or metal shears for cutting notches
Common Mistakes
- Setting edging flush with no gaps on a sloped lawn, which traps runoff against the lawn side.
- Making notches too small. Openings under 1 inch often clog with mulch or soil.
- Skipping the gravel base in clay soil, where water sits and heaves the edging.
- Placing weep points on the high side of the border, where they do nothing.
- Forgetting to check after the first heavy rain, when minor adjustments are easiest.
Recommended Gear
A sturdy spade with a straight edge makes trenching faster and keeps the cut clean for gravel bases. View on Amazon
A torpedo level helps you confirm each section’s grade before backfilling, which is the step most people skip. View on Amazon
FAQ
How wide should gaps be in landscape edging?
A joint of 1/4 inch to 1/2 inch works for most stone and paver edgings. Filling the gap with pea gravel keeps soil from washing through while still letting water pass.
Do I need drainage in edging on flat ground?
On flat, well-drained soil, a solid edge is usually fine. Add openings anyway if your yard collects standing water after rain or receives runoff from a downspout.
Can I add weep holes to existing edging?
Yes. Metal and plastic strips can be notched with a hacksaw or metal shears, and stone can be re-set with gaps. Work at the low points first.
Conclusion
Landscape edging that allows drainage needs only a few deliberate openings placed at the low points of your slope. Check the grade before you set anything, use gravel bases in heavy soil, and test with a hose once the border is in. A few minutes of planning keeps your lines clean through every storm.
