Updated November 2026
Learning how to install landscape edging plastic takes a few hours of focused work and a basic set of tools. When you finish, you will have a crisp, stable border between your lawn and your beds that holds its line through mowing and rain. The process comes down to marking the route, cutting a trench to the right depth, setting the strips level and anchoring them firmly.
Gather Your Tools and Plan the Route
Before you dig, lay out the path you want. A garden hose works well for curves, and spray paint or marking flour shows the final line. Measure the total run so you know how many strips to buy, and add about 10 percent extra for cuts and mistakes.
Shopping for one? See our guide: 6 Best Install Plastic Landscape Edgings (2026): Our Picks.
- Plastic edging strips and matching stakes or spikes
- Half-moon edger or flat spade
- Garden hose, marking paint or flour
- Hand tamper or the back of a shovel
- Tape measure, level and a rubber mallet
- Hacksaw or a utility knife for cutting the plastic
Dig the Trench to the Correct Depth
Cut along your marked line with a half-moon edger, keeping the blade vertical. Dig a trench roughly 2 to 3 inches deep and just wide enough for the strip. Most plastic edging is set so that about 1 inch sits above grade. That height keeps grass from creeping over the top without making a barrier that snags the mower. For a deeper look, Basketball Ring for Trampoline: How to Choose and Install One Safely covers this in detail.
Remove loose soil and roots, then tamp the trench bottom firmly. A flat, compacted base keeps the strips from sinking unevenly over time.
Set and Anchor the Strips
Lay the first strip in the trench and check it with your level, both along its length and from side to side. Overlap or join sections according to the manufacturer’s connector method, then slide the stakes or spikes through the pre-punched holes. Space stakes about 12 to 18 inches apart on straight runs and closer on curves.
Drive each stake with a rubber mallet until its top sits just below the edging’s top edge. Recheck alignment after every few feet. If you need to cut a strip to length, use a hacksaw or a sharp utility knife and smooth the cut end before joining.
Backfill and Finish the Edge
Once the strips are secure, backfill the outer side with soil and tamp it lightly. This locks the edging against the lawn side and prevents grass from rolling underneath. Water the area and check the line again after a few days, since soil can settle.
Common Mistakes to Avoid
- Setting the strip too high, which makes mowing hard and invites tripping
- Skipping the tamping step, leading to wobbly or sinking sections
- Spacing stakes too far apart, so the edging bows between them
- Installing in wet or frozen soil, which makes the trench hard to shape
- Forgetting to check the level after the first few feet
Recommended gear
A half-moon edger helps you cut a clean, vertical trench without tearing the turf. View on Amazon
A rubber mallet drives stakes without cracking the plastic or bending the spikes. View on Amazon
FAQ
How deep should plastic landscape edging go?
Most plastic strips are set with 2 to 3 inches buried and about 1 inch above the soil line. Check the packaging for the specific depth your product requires.
Can I install plastic edging without digging?
Some kits are designed for no-dig installation, but they usually rely on stakes and a firm base. A trench still gives the most stable, lasting result, especially on slopes.
How far apart should the stakes be?
A common spacing is about 12 to 18 inches on straight sections, with closer placement on curves. Follow the manufacturer’s guidance if it differs.
Conclusion
Mark your route, cut a level trench and set the strips so they sit about an inch above grade. Anchor them with stakes at consistent spacing and backfill firmly. A careful installation gives you clean lines that last through many mowing seasons.
