Updated November 2026

To ryobi 40v trimmer replace string, you remove the spool, cut fresh line to the length the manufacturer specifies, wind it in the correct direction and reinstall the spool so both ends feed through the eyelets. The whole job usually takes under ten minutes and needs no tools beyond what is in your hands. Once the new line is seated, the trimmer should feed cleanly and cut at full speed.

What You Need Before You Start

Gather everything first so you are not stopping mid-job with the spool in pieces. Check your owner’s manual for the correct line diameter and length, since 40V models vary by head design.

Shopping for one? See our guide: Top 7 Lawn Edger String Trimmer Combos for Clean Lines (2026).

  • Replacement trimmer line matching the diameter in your manual
  • Scissors or a utility knife for cutting line
  • A clean, flat workspace
  • Gloves, if you prefer them when handling the head

Step-by-Step: Replacing the Line

Step 1: Disconnect the battery

Remove the battery pack before touching the cutting head. This removes any chance of the motor starting while your fingers are near the spool.

Step 2: Remove the spool cover and old spool

Press the tabs on the head cover or turn the cover counterclockwise, depending on your model, and lift it off. Pull out the spool and any old line still wound on it. Note how the spool sits so you can reinstall it the same way.

Step 3: Cut and wind the new line

Cut two pieces of line to the length in your manual, often somewhere in the range of 15 to 20 feet for a single spool. Find the center point, then wind both ends in the direction arrow printed on the spool. Leave a few inches of each end free.

Step 4: Thread the ends through the eyelets

Feed each end through its eyelet on the spool, then pull the line so the spool sits flush inside the housing. Most heads have a notch or arrow that tells you where each end exits.

Step 5: Reinstall the spool and cover

Seat the spool, replace the cover and align the tabs or threads until it clicks or locks. Reconnect the battery and test the head by holding the trimmer off the ground and running it briefly.

Common Mistakes to Avoid

  • Winding the line against the arrow, which causes the head to feed poorly or not at all.
  • Using line that is too thick, which can overload the motor and strip the spool.
  • Forgetting to disconnect the battery before opening the head.
  • Leaving the line ends too short, so they slip back inside the spool.
  • Tightening the cover unevenly, which can let the line tangle or jam.
  • Ryobi 40V trimmer line: Matches the diameter and spool design these trimmers expect, which helps the line feed reliably. View on Amazon
  • Replacement spool for Ryobi 40V trimmers: Useful if your existing spool is cracked or worn, since a fresh spool keeps the line feeding properly. View on Amazon

FAQ

How often should I replace the trimmer line?

Replace it when the line is too short to reach the cutting edge or when it breaks often during use. Heavy trimming around fences and edges wears line faster than light grass work.

Can I use any line diameter in my Ryobi 40V trimmer?

No. Use the diameter listed in your owner’s manual, since a thicker line can overload the motor. Thinner line may break too quickly for dense grass.

What if the line won’t feed out after I reinstall the spool?

Check that the line is wound in the direction of the arrow and that both ends pass through the eyelets. If the problem continues, consult the manufacturer or a qualified repair technician.

Conclusion

Replacing the line on a Ryobi 40V trimmer is a quick job once you know the steps. Keep the battery disconnected, wind the line in the correct direction and match the diameter to your manual. Handled this way, the trimmer will cut cleanly and feed without trouble.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our lawn edging & trimming guides, checking product details against manufacturer specifications and owner feedback.