Caleb MorganBy Caleb Morgan

Updated November 2026

Vigoro landscape edging no-dig products let you define clean lawn borders without trenching or digging out sod. You will learn how to plan the bed line, lay the edging, anchor it so it holds through mowing and freeze-thaw cycles, and maintain a crisp finish. Most homeowners can complete a straight run of edging in an afternoon with basic hand tools.

Plan the Layout Before You Buy or Unroll Anything

Start by marking the border with a garden hose or a length of spray paint. Curves should have a smooth radius, since sharp corners make no-dig edging buckle and gap. Measure the total run in feet so you buy enough material, and add about 10 percent for overlaps and cuts.

Shopping for one? See our guide: 6 Best Vigoro 100 Ft Heavy Duty No-Dig Plastic Landscape Edgings (2026).

Check that the grade slopes away from the bed, not toward the lawn. Water that pools against the edge will push soil and mulch over the top over time. If you are unsure which product fits your bed style, compare options in Vigoro No-Dig Landscape Edging Kit: A Step-by-Step Install Guide before you commit.

Install the Vigoro No-Dig Edging Section by Section

Most no-dig systems rest on the soil surface and rely on stakes or spikes for hold. Work in sections of 6 to 8 feet so you can keep the line straight as you go.

  1. Clear grass, weeds, and debris along the marked line. Leave the soil surface as level as you can.
  2. Set the first section at a starting point, such as a corner or a fence line.
  3. Lay the next section end to end, joining according to the manufacturer’s connector method.
  4. Drive anchoring spikes or stakes through the pre-punched holes at each joint and roughly every 12 to 18 inches on straight runs.
  5. Check alignment with a string line after every few sections and adjust before the final spikes are fully seated.

For a detailed walkthrough of spike placement, see No-Dig EasyFlex Landscape Edging: A Step-by-Step Install Guide, which covers similar anchoring logic.

Anchor the Edging So It Stays Put

Anchoring is where most no-dig installations fail. Spikes should be driven straight down, flush with or slightly below the top surface of the edging. A spike driven at an angle loosens quickly under mower traffic.

In sandy or loose soil, add spikes closer together. In compacted clay, pre-soak the ground lightly so the spikes seat without bending. If the ground is frozen or rock-hard, delay installation until conditions improve.

Finish the Border and Plan Ongoing Care

Once the edging is set, backfill the bed side with mulch or soil so the top edge is slightly above the lawn grade. This shields the edge from mower wheels and keeps the line visible. Trim any grass that grows over the top with a string trimmer held at a low angle.

Tools and Supplies Checklist

  • Garden hose or marking paint for layout
  • String line and tape measure
  • Rubber mallet or hammer for seating spikes
  • Utility knife for cutting sections
  • Manufacturer’s anchoring spikes and connectors

Common Mistakes

  • Skipping the level check, which causes sections to rise and fall over time.
  • Using too few spikes on curves, where edging tends to pull outward.
  • Leaving the bed side lower than the lawn, letting mulch wash onto the grass.
  • Driving spikes at an angle instead of straight down.
  • Installing during a heavy rain or on waterlogged soil.
  • Rubber mallet helps seat spikes without damaging the edging surface. View on Amazon
  • Hand-held string trimmer keeps the top edge clean once the bed is backfilled. View on Amazon

FAQ

Can I install vigoro landscape edging no-dig over existing grass?

Yes, but remove the grass directly under the footprint of the edging, or the strip may lift and create a gap. Clearing a narrow strip keeps the base seated flat against the soil.

How many spikes do I need per foot?

On straight runs, one spike every 12 to 18 inches is a common starting point, with more on curves and in loose soil. Always follow the spacing the manufacturer specifies for your product.

Will vigoro no-dig edging hold up to a lawn mower?

It can, provided the spikes are fully seated and the top edge sits slightly above grade. Mowers that run close to the edge will eventually wear the top, so keep the mower wheels a few inches from the line.

Conclusion

A well-planned vigoro landscape edging no-dig installation gives you clean borders in a single afternoon. Lay out the line carefully, anchor every section with straight-down spikes, and backfill the bed side. With those steps, your edge should stay sharp for seasons to come.

Ready to choose one?

Caleb Morgan

About Caleb Morgan

Caleb Morgan is part of our editorial team and reviews and edits our lawn edging & trimming guides, checking product details against manufacturer specifications and owner feedback.